LNYD SHOCK ABSORBING 200TO350LB 6FT 2

Product Description

The Peakworks Shock-Absorbing Lanyard is a 6 ft twin-leg fall arrest lanyard featuring an integrated energy absorber, designed for workers within the 200 to 350 lb capacity range. The twin-leg configuration provides two independent connection legs, allowing workers to maintain 100% tie-off during transitions between anchor points — a critical requirement in applications such as steel erection, tower climbing, and other work environments where continuous fall protection must be maintained while moving between anchor locations. The energy absorber deploys during a fall arrest event, tearing open in a controlled manner to dissipate kinetic energy and limit the maximum arrest force transmitted to the worker's body to within established safety thresholds.

The 200 to 350 lb capacity range accommodates heavier workers or those carrying substantial tools and equipment, where a standard-capacity lanyard would be insufficient. Selecting a lanyard with the correct capacity range is essential to ensure the energy absorber deploys correctly and limits arrest forces as designed for the worker's actual weight. The 6 ft length provides extended reach from the anchor point to the harness dorsal D-ring, making it suitable for applications where the anchor point is positioned at or slightly above the worker's level, though fall clearance requirements must be carefully evaluated when using a longer lanyard length.

This lanyard must be connected to the dorsal D-ring of a compatible full-body harness and each leg connected to suitable anchor points rated for fall arrest loads. Only one leg should be loaded in a fall arrest event at any time — the second leg is used to connect to the next anchor point before disconnecting the first, maintaining continuous protection during transitions. Sufficient fall clearance below the worker must be confirmed before use, accounting for lanyard length, energy absorber deployment extension, harness stretch, and worker height. Inspect the lanyard, both legs, and the energy absorber before each use and remove from service immediately if the energy absorber has been deployed or any defects are identified.

Material: Webbing construction (verify specific material with Peakworks product documentation) Integrated energy absorber pack Steel or alloy snap hooks or carabiners (verify connector type and material with Peakworks product documentation)

Compatible With: Full-body harnesses with dorsal D-ring fall arrest attachment rated for the 200 to 350 lb capacity range Fall arrest anchor points rated for applicable loads

Uses: Twin-leg fall arrest lanyard for 100% tie-off during anchor point transitions Steel erection, tower climbing, and structural work at height Construction and industrial maintenance requiring continuous fall protection Applications requiring energy absorption to limit arrest forces for heavier workers

Key Features: 6 ft length Capacity range: 200 to 350 lb Twin-leg configuration for 100% tie-off during anchor point transitions Integrated energy absorber to limit maximum arrest force during fall arrest Suitable for heavier workers and those carrying substantial tools and equipment

Note: Always confirm the worker's total weight including tools and equipment falls within the 200 to 350 lb rated capacity range before use. Confirm sufficient fall clearance below the work position before use, accounting for lanyard length, energy absorber deployment extension, harness stretch, and worker height. Only one leg should be loaded in a fall arrest event at any time. A deployed energy absorber indicates the lanyard has arrested a fall — remove from service immediately and do not reuse. Inspect before every use and retire from service if any damage or defect is detected.