LIFELINES 310LB 10FT

Product Description

The Peakworks Lifeline is a 10 ft vertical lifeline rated to 310 lb, designed for use in personal fall arrest systems where a short lifeline length is required by the work area configuration or structure height. The 10 ft length is suited for applications where the anchor point is positioned close to the worker's connection point, such as on low elevated platforms, short fixed ladder runs, or specific work positioning configurations where a longer lifeline would create excessive slack, entanglement risk, or insufficient fall clearance. The 310 lb capacity accommodates workers within the specified weight limit including tools and equipment carried on the person.

This lifeline is intended for use as part of a complete personal fall arrest system in conjunction with a compatible full-body harness, a rope grab device compatible with the lifeline rope diameter and construction, and a suitable anchor point rated for fall arrest loads. The lifeline must be anchored above the work area and the rope grab positioned correctly on the line before work begins. Due to the short length of this lifeline, fall clearance calculations are especially important — the total fall clearance below the worker must be confirmed to be sufficient for the fall arrest system being used, accounting for rope grab travel, energy absorber deployment if applicable, harness stretch, and worker height. A short lifeline does not inherently provide adequate fall clearance and a competent person must evaluate the complete system configuration before work begins.

Inspect the lifeline before each use for fraying, kinking, chemical damage, discoloration, or any other signs of deterioration. Remove from service immediately if any defects are identified. Always follow applicable fall protection regulations and the manufacturer's instructions when deploying this lifeline, and ensure a competent person has evaluated the fall clearance and system configuration before work begins.

Material: Rope construction (verify specific rope material and diameter with Peakworks product documentation)

Compatible With: Rope grab devices compatible with lifeline rope diameter and construction Full-body harnesses with dorsal D-ring fall arrest attachment Fall arrest anchor points rated for applicable loads

Uses: Vertical lifeline for personal fall arrest systems requiring short lifeline length Low elevated platforms and short fixed ladder run applications Work positioning configurations where minimal slack and compact deployment are required Work areas where the anchor point is close to the worker's connection point

Key Features: 310 lb capacity 10 ft length for short-reach vertical lifeline applications For use as part of a complete personal fall arrest system Suitable for applications where anchor point proximity requires a short lifeline

Note: Fall clearance calculations are critical with this lifeline due to its short length. A competent person must confirm total fall clearance is sufficient before use, accounting for rope grab travel, energy absorber deployment if applicable, harness stretch, and worker height. Verify rope grab compatibility with lifeline rope diameter and construction before use. Inspect before every use and retire from service upon detection of any damage or defect.