REBAR ASSEMBLY 2FT SNAP HOOK/FORM

Product Description

The Peakworks Rebar Assembly is a 2 ft anchorage connector designed to provide a secure and compliant tie-off point when working around rebar, formwork, and structural steel in construction environments. The assembly loops around or attaches to rebar or form structures and presents a snap hook connection point for attaching a lanyard, self-retracting lifeline, or other fall arrest component. This type of anchorage connector is a practical solution for concrete construction, foundation work, and elevated formwork applications where dedicated anchor points may not yet be installed.

The 2 ft length provides sufficient reach to wrap around rebar bundles, form ties, or structural members of varying sizes while maintaining a secure and stable connection. The integrated snap hook allows for quick and tool-free connection and disconnection, improving efficiency during work positioning and transitions between anchor points. The assembly is engineered to meet the load requirements of a personal fall arrest system when properly anchored to a suitable structural member.

This rebar assembly should only be used on structural rebar or formwork that has been confirmed to be capable of supporting fall arrest loads as required by applicable standards. Always inspect the assembly before each use for signs of wear, corrosion, deformation, or damage to the snap hook, webbing, or hardware, and remove from service immediately if any defects are found. Follow all applicable fall protection regulations and manufacturer guidelines when incorporating this assembly into a fall arrest system.

Material: Webbing strap (verify specific material with Peakworks product documentation) Steel snap hook

Compatible With: Structural rebar and formwork suitable for fall arrest anchorage loads Compatible lanyards, SRLs, and fall arrest components with mating connectors

Uses: Temporary anchorage on rebar and formwork in concrete construction Foundation and elevated slab work Structural steel and form tie anchorage Fall arrest system tie-off point in construction environments

Key Features: 2 ft length for versatile wrap-around anchorage on rebar and form structures Integrated snap hook for quick, tool-free connection Designed for use as a temporary anchorage connector in fall arrest systems Suitable for concrete construction, foundation work, and elevated formwork applications

Note: Only anchor to structural rebar or formwork confirmed capable of supporting fall arrest loads per applicable regulations. Inspect before every use and retire from service if any damage or defect is detected.