HARNESS SAF S PASS-THRU PASS-THRU FRICT

Description du produit

The Peakworks Safety Harness is a small full-body harness featuring pass-thru buckle leg straps and friction buckle adjustment, designed to provide secure, reliable fit and fall arrest performance for smaller workers in construction, industrial maintenance, and general work-at-height applications. Pass-thru buckles on the leg straps provide a positive, secure connection that must be threaded and latched correctly before use, offering a reliable leg strap closure that resists accidental disengagement during work at height. Friction buckles provide tool-free strap length adjustment throughout the harness, allowing workers to quickly and precisely adjust the harness to achieve a correct and snug fit before beginning work.

The combination of pass-thru leg buckles and friction adjustment buckles provides a balance of secure positive-latch leg strap closure and flexible, easy-to-adjust strap length control across the harness. Proper harness fit is especially critical for smaller workers — a small harness must be correctly adjusted to fit snugly against the body at all contact points without excessive slack, as an improperly fitted harness can shift during a fall arrest event and fail to distribute arrest forces correctly across the worker's body. Straps must be adjusted so the harness fits snugly without restricting movement or circulation, with the dorsal D-ring centered between the shoulder blades, the chest strap positioned at mid-sternum level, and the leg straps fitting snugly around the upper thighs with the pass-thru buckles fully latched and verified before work begins.

This harness must be used as part of a complete personal fall arrest system with a compatible shock-absorbing lanyard, self-retracting lifeline, or other connecting subsystem, and a suitable anchor point rated for fall arrest loads. Inspect the harness before each use for webbing wear, fraying, cuts, chemical damage, discoloration, buckle and hardware defects, and stitching integrity. Remove from service immediately if any defects are identified or if the harness has been subjected to fall arrest forces. Always follow the manufacturer's donning, adjustment, and inspection instructions and applicable fall protection regulations.

Material: Webbing construction (verify specific material with Peakworks product documentation) Hardware (verify specific buckle and hardware material with Peakworks product documentation)

Compatible With: Compatible shock-absorbing lanyards, self-retracting lifelines, and rope grab devices for fall arrest Fall arrest anchor points rated for applicable loads

Uses: Full-body harness for personal fall arrest systems Construction, industrial maintenance, and general work-at-height applications for smaller workers Applications where pass-thru leg buckles are preferred for positive-latch leg strap closure Applications where friction buckle adjustment is preferred for quick and precise fit adjustment

Key Features: Small sizing for smaller workers Pass-thru buckle leg straps for positive-latch, secure leg strap closure Friction buckle adjustment for tool-free, precise strap length adjustment Dorsal D-ring fall arrest attachment point

Note: Always verify pass-thru leg buckles are fully threaded and latched before beginning work. Correct harness fit is especially critical for smaller workers — inspect and adjust all straps carefully before each use, verifying the dorsal D-ring is centered between the shoulder blades and all straps are snug and correctly positioned with no excessive slack. A harness that has been subjected to fall arrest forces must be removed from service immediately and must not be reused. Inspect before every use and retire from service if any damage, defect, or fall arrest event is detected.