LIFELINE 400LB 25FT ANSI Z359 POLYSTEEL

Description du produit

The Peakworks Polysteel Lifeline is a 25 ft vertical lifeline rated to 400 lb and manufactured to meet ANSI Z359 fall protection standards. Polysteel rope construction combines a polyester outer braid with an internal steel wire core, providing the handling flexibility of a synthetic rope alongside the cut resistance, abrasion resistance, and tensile strength of a steel core. This construction makes it well suited for industrial environments where standard synthetic ropes may be at risk from sharp structural edges, abrasive surfaces, or mechanical hazards commonly encountered on construction and industrial job sites.

Compliance with ANSI Z359 ensures the lifeline meets established performance requirements for fall protection equipment used in general industry and construction applications across North America. The 400 lb capacity accommodates a wide range of workers and tool weights, and the 25 ft length is well suited for applications on structures of low to moderate height including elevated platforms, mezzanines, fixed ladders, tanks, and single-story or low-rise construction. The 25 ft length offers a practical balance between reach and manageability, reducing excess rope below the working position compared to longer lifeline variants while still providing adequate coverage for many common work-at-height scenarios.

This lifeline is intended for use as part of a complete personal fall arrest system in conjunction with a compatible full-body harness, a rope grab device rated for polysteel rope, and a suitable anchor point capable of supporting fall arrest loads. The lifeline must be anchored above the work area before use. Inspect the full length of the rope before each use for fraying, kinking, core wire protrusion, chemical damage, or any other deterioration, and remove from service immediately if any defects are identified.

Material: Polysteel rope (polyester outer braid with steel wire core)

Compatible With: Rope grab devices rated and compatible with polysteel lifeline rope Full-body harnesses with dorsal D-ring fall arrest attachment Fall arrest anchor points rated for applicable loads

Uses: Vertical lifeline for personal fall arrest systems Elevated platforms, mezzanines, and fixed ladder applications Low-to-moderate height construction and industrial maintenance Tank and single-story structure applications

Key Features: 400 lb capacity 25 ft length for low-to-moderate height applications Polysteel construction: polyester outer braid with steel wire core Enhanced cut and abrasion resistance versus synthetic-only rope Meets ANSI Z359 fall protection standards

Note: Always verify rope grab compatibility with polysteel lifeline diameter and construction before use. Anchor above the work area to a suitable fall arrest anchor point. Inspect the full rope length before every use and retire from service upon detection of any damage or defect.